Sailing

Series 7 Stand Up Ball Bearing Swivel Block - 2-3/8" 60mmSingle stand up ball bearing block. Stand up spring keeps block upright when not in use. Stainless steel base spreads load out and may be used with 97-49 backing plate. (sold separately)...

Pro Splicing KitKit Includes:Ronstan splicing bagSplicing kit, 5 fid set (4, 5.5, 7.5, 10, 13 mm)Scissors, 8" cuts Kevlar and Dyneema materialF15 puller small, 2-4 mm lineF25 puller, 6-8 mm lineSplicing tape5 piece needle setSmall Swedish fidLeather...

Spreader Flag Halyard KitIncludes 40ft. of polyester line, block with bail and shroud cleat.

Pulpit Anchor for 1" RailThis fitting can be used on the stern rail and bow pulpit to terminate jaw fittings for lower or upper life lines. (1/2" hole). The hole will not accept cast gate hooks. 

Eye to Deck Toggle FittingThis fitting can be mounted to any flat surface and accept life line fittings, line, etc. Toggling action is 140 degrees. 

Eye to Jaw FittingThis fitting will convert a small bail at the stern rail to the standard gate eye to accept the over center gate hook.

Eye to Eye Adjustable FittingThis fitting can be used wherever an eye is required on each side of the stanchion. Adjustable between 3/4" and 1". 

Short Adjuster for 3/16" WireGenerally used at the stern rail in conjunction with the single gate eye to tension that section of the gate.Specifications:3/16" Wire1/4" Pin1" adj.

Short Adjuster for 1/8" WireGenerally used at the stern rail in conjunction with the single gate eye to tension that section of the gate.Specifications:1/8" Wire1/4" Pin1" adj.

"T" Style Toggle Jaw for 3/16" WireGenerally used at the stern rail when no gate is required with a turnbuckle forward.

"T" Style Toggle Jaw for 1/8" WireGenerally used at the stern rail when no gate is required with a turnbuckle forward.

Deck Toggle "T" Style for 3/16" WireThis fitting can be used wherever a cable needs to be terminated to a deck or bulkhead.