Sailing

Series 5 Fiddle Swivel Block- 54mmPlain Bearing BlocksBarton plain bearing blocks have a precision moulded acetal sheave running on a large diameter brass bearing, ensuring free running under the highest of loads.SpecificationsSheave size: 54mm x...

Series 5 Fiddle Reverse Shackle Block - 54mmPlain Bearing BlocksBarton plain bearing blocks have a precision moulded acetal sheave running on a large diameter brass bearing, ensuring free running under the highest of loads.SpecificationsSheave size:...

Pro Splicing KitKit Includes:Ronstan splicing bagSplicing kit, 5 fid set (4, 5.5, 7.5, 10, 13 mm)Scissors, 8" cuts Kevlar and Dyneema materialF15 puller small, 2-4 mm lineF25 puller, 6-8 mm lineSplicing tape5 piece needle setSmall Swedish fidLeather...

Spreader Flag Halyard KitIncludes 40ft. of polyester line, block with bail and shroud cleat.

Pulpit Anchor for 1" RailThis fitting can be used on the stern rail and bow pulpit to terminate jaw fittings for lower or upper life lines. (1/2" hole). The hole will not accept cast gate hooks. 

Eye to Deck Toggle FittingThis fitting can be mounted to any flat surface and accept life line fittings, line, etc. Toggling action is 140 degrees. 

Eye to Jaw FittingThis fitting will convert a small bail at the stern rail to the standard gate eye to accept the over center gate hook.

Eye to Eye Adjustable FittingThis fitting can be used wherever an eye is required on each side of the stanchion. Adjustable between 3/4" and 1". 

Short Adjuster for 3/16" WireGenerally used at the stern rail in conjunction with the single gate eye to tension that section of the gate.Specifications:3/16" Wire1/4" Pin1" adj.

Short Adjuster for 1/8" WireGenerally used at the stern rail in conjunction with the single gate eye to tension that section of the gate.Specifications:1/8" Wire1/4" Pin1" adj.

"T" Style Toggle Jaw for 3/16" WireGenerally used at the stern rail when no gate is required with a turnbuckle forward.

"T" Style Toggle Jaw for 1/8" WireGenerally used at the stern rail when no gate is required with a turnbuckle forward.